Notes

Notes:
______________


I was taping with taper buddy, John DeTally and we were up front in the quite zone with John Ammons, and I think Clay and or Sean, though I am not sure of who exactly we were with, we were acting as quiet blockers and redirecting folks around as best we could. John DeTally and I took turns wearing the mics and running the decks, both WM-D6C's Mine first then his. The blanket space was about half way between the house soundboard mix position and the stage and was fairly large I believe it was 4 large king size tie died sheets sewn together... plus made a few others surrounding the quite fob taping zone... It sounds very sweet way up in there.

I had DIY'd my To a K1 capsules to be "active" from the bodies sometime in 1988 , I believe. Later Some on I knew "machines some threaded parts, though out of aluminum, and with the fine threading it proved to be too soft and would occasionally lose connections, I think for this run I simply had the cables electrical taped on to the caps and bodies. There were multiple pops and high transient clips and crackles, in the left channel. I only ran 12/27 and 12/28 upfront, I did not want the stress on 12./30 or 12/31 so I ran from way in the back in the Official Taping Section (OTS) which was not even on the floor, but in the back elevated stands.
Finally I am able to master both of these FOB nights, and use the right channel to patch the left, where needed. It is certainly a labor of love, but well worth the effort I hope that you enjoy the recordings too.

No EQ or other effects were applied.


Tech Notes:

first 3 minutes of set 1 had multiple patches in LTGTR with the right used for left (AKA mono). Only about 30 seconds of LTGTR patched.
The rest of set one is unpatched.

No patches in second set

For many years this was the only source I had to listen to my own and is why I started taping, so I could hear the shows I attended.

enjoy - ArchivalAudio